Minute Man SSL-SMOKE manual

Minute Man SSL-SMOKE
9.3 · 1
PDF manual
 · 3 pages
English
manualMinute Man SSL-SMOKE

SSL-SMOKE User’s Manual

IMPORTANT: Read all of the instructions before
attempting to install the SSL-SMOKE detector.
DESCRIPTIONS
The SSL-SMOKE detector is a device, which connects with
SSL-EMD. When smoke is detected an alarm will sound
alerting the users. Through the SNMP-SSL card, the user can
monitor it and receive notifications of the alarms.

This type o

f
A

C/DC smoke detector can be powered by 120VAC utility

power or

a 9-volt battery. AC/DC smoke detectors offer added
protection in the event of a power failure or a dead battery.
INSTALLATION
1. Detach the cover by twisting it until it unlatches from the
smoke detector base.
2. Using the smoke detector base as pattern, trace outlines o
f
the two keyhole slots onto the mounting surface.
3. Drill a pilot hole in the center of the small end of each of the
keyhole slots in the mounting surface.
4. Insert and tighten the mounting screws in the pilot holes
leaving approximately 1/8” of the screws sticking out.
5. Mount the smoke detector base making sure that screws
are positioned in the small ends of the keyholes and tighten
the screws.
6. Snap on the battery wire clip and insert the battery into
battery holder.
7. Replace the cover by twisting it until it latches. The smoke
detector is now operating.
8. Test the smoke detector by pushing test button on cove
r
and holding the button down for about 2-seconds.
Use the following steps to set-up and connect the
SSL-SMOKE detector to the SSL-EMD:
1. Loosen the screws on SSL-EMD.
2. Connect the wires from the SSL-SMOKE detector to the
SSL-EMD Alarm-1 and/or Alarm-2, and then tighten the screws.
3. Connect the straight-through CAT5 network cable from the
SNMP-SSL card’s RJ45 connector labeled “COM” to the
connector labeled “010101” on the SSL-EMD.
4. Verify that the SNMP-SSL card has a network connection and
is powered on.
5. Check the LED (Power/Status) of SSL-EMD, it will flash ever
y
5-seconds.
6. Open a Web browser and connect to the SNMP-SSL card.
7. Change the setting of “SSL-EMD Status” from “Disable” to
“Auto” on the EMD Configuration page.
8. Set the status of Alarm-1 and/or Alarm-2 to “Normal Open”.
9. The installation of the SSL-SMOKE detector is complete. See
the SNMP-SSL User’s Manual.
Note: The SSL-SMOKE detector operates with 120VAC or a
9-volt battery. Connecting to the 120VAC utility power is not
required to operate the detector. However, operating with both
the utility power and the battery offers added protection in the
event of a power failure or a dead battery.
LIMITED PRODUCT WARRANTY
Para Systems Inc. (Para Systems) warrants this equipment, when
properly applied and operated within specified conditions, against
faulty materials or workmanship for a period of three years from the
date of original purchase by the end user. For equipment sites within
the United States and Canada, this warranty covers repair o
r
replacement of defective equipment at the discretion of Para Systems.
Repair will be from the nearest authorized service center.
Replacement parts and warranty labor will be borne by Para Systems.
For equipment located outside of the United States and Canada, Para
Systems only covers faulty parts. Para Systems products repaired o
r
replaced pursuant to this warranty shall be warranted for the remaining
portion of the warranty that applies to the original product. This
warranty applies only to the original purchaser who must have properl
y
registered the product within 10 days of purchase.
The warranty shall be void if (a) the equipment is damaged by the
customer, is improperly used, is subjected to an adverse operating
environment, or is operated outside the limits of its electrical
specifications; (b) the equipment is repaired or modified by anyone
other than Para Systems or Para Systems-approved personnel; or (c)
has been used in a manner contrary to the product's operating manual
or other written instructions.
A
ny technical advice furnished before or after delivery in regard to use
or application of Para Systems’s equipment is furnished without charge
and on the basis that it represents Para Systems’s best judgment
under the circumstances, but it is used at the recipient's sole risk.
EXCEPT AS PROVIDED HEREIN, PARA SYSTEMS MAKES NO
WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
A
PARTICULAR PURPOSE. Some states do not permit limitation o
f
implied warranties; therefore, the aforesaid limitation(s) may not apply
to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL PAR
A
SYSTEMS BE LIABLE FOR DIRECT, INDIRECT, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF
THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGE. Specifically, Para Systems is not
liable for any costs, such as lost profits or revenue, loss of equipment,
loss of use of equipment, loss of software, loss of data, cost o
f
substitutes, claims by third parties, or otherwise. The sole and
exclusive remedy for breach of any warranty, expressed or implied,
concerning Para Systems’s products and the only obligation of Para
Systems hereunder, shall be the repair or replacement of defective
equipment, components, or parts; or, at Para Systems’s option, refund
of the purchase price or substitution with an equivalent replacement
product. This warranty gives you specific legal rights and you may
also have other rights, which vary from state to state.
OBTAINING TECHNICAL ASSISTANCE
Para Systems (Minuteman UPS) Technical Support:
Phone: 1-972-446-7363
Fax: 1-972-446-9011
Web: www.minutemanups.com/support/con_tech2.php
www.minutemanups.com © Copyright 2008 34000363 R1
s

View the manual for the Minute Man SSL-SMOKE here, for free. This user manual comes under the category Smoke detectors and has been rated by 1 people with an average of a 9.3. This manual is available in the following languages: English. Do you have a question about the Minute Man SSL-SMOKE? Ask your question here

Got a question?

Do you have a question about the Minute Man and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Minute Man owners to provide you with a good answer.

Number of questions: 0

General
Minute Man
SSL-SMOKE | SSL-SMOKE
Smoke detector
784755154354, 7847551543548, 0784755154354
English
manual_type_manual (PDF)
Technical details
Detector type-
Interconnectable-
Connectivity technologyWired
Product colourBlack,Grey
Power
Power sourceAC/DC
Battery voltage9 V
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Minute Man SSL-SMOKE below.

Is your question not listed? Ask your question here

No results